Bartolini 108G67J1-T 7-String G6 Candybar Original Dual In-Line Coil Bridge Pickup

Bartolini 108G67J1-T 7-String G6 Candybar Original Dual In-Line Coil Bridge Pickup

Based on our legendary Original series J-Bass pickups with dual-inline, split coils, these pickups cancel hum while providing that full and warm vintage tone you've been craving, enhancing the natural voice of your bass. Original Barts bring out your voice, low and clear.

In the early ?70s, Bill Bartolini leveraged his deep knowledge of acoustics to create pickups that produce the most natural, musical voice from the instrument. He added shielding to block radio signals and noise. He developed a method of sealing, isolating, and stabilizing the coils so they could be encapsulated in epoxy to eliminate "microphonics" ? the nasty noise you get when you touch typical pickups.

Candybar shapes were made for refined Jazz bass builders who wanted to avoid the routing hassles and busy look of standard J-Bass pickups. Available in versions for neck (Bass, -B) and bridge (Treble, -T).

Specifications

• Coil Structure: Dual Inline Hum-killing
• Cable Type: Shielded Coaxial Hot Core
• Magnetic Circuit: 2 types of carbon steel powered by ceramic (ferrite) magnets. Opposite polarity for neck and bridge

108G67J1-B - Neck

• DC Resistance: ~9.8KΩ
• Resonant Frequency: ~5.8KHz
• Sensing Width: 4.25" [108mm] Max - 2.83" [72mm] Min

108G67J1-T - Bridge

• DC Resistance: ~11.1KΩ
• Resonant Frequency: ~4.9KHz
• Sensing Width: 4.25" [108mm] Max - 2.83" [72mm] Min

G6 Candybar

• 5.52" [140.2mm] Long, 0.93" [23.7mm] Wide, 0.74-0.84" [18.8-21.3mm] Thick + 0.11" [2.8mm] Cable
• 1 hole on bass end upper left and 1 on treble end lower right for your #4 pan head screws

Please Note: Bartolini does not supply screws with their pickups. If you require pickup screws, we carry them on our pickup screws page.

Click Here for Pickup Screws.