Bartolini XXP26M-B 6-String P2 Soapbar Original Split Coil Neck

Bartolini XXP26M-B 6-String P2 Soapbar Original Split Coil Neck

Voiced very similar to our Original Dual Coil bass pickups, our Split-coil Reverse P design provides extended reach and a wider sensing area, allowing for a narrower pickup to work with wider-spaced strings. Original Split pickups preserve the full-bodied low end of our Original series and adding even more articulation, a simple setup, and high value.

Original Splits provide you with deep lows and low-mids along with nice treble complexity for manageable growl. The coils are fully shielded and sealed so they are sweat-proof and immune from invisible noise stage and studio equipment. The cables are shielded too.

Available in balanced versions for neck (Bass, -B) and bridge (Treble, -T). The bridge pickup has a higher output than the neck pickup, so it is great for cutting through the mix when needed.

Specifications

• Coil Structure: Split Reverse P Hum-killing
• Cable Type: Shielded Coaxial Hot Core
• Magnetic Circuit: 3 types of Carbon steel and brass powered by ceramic (ferrite) magnets projected shallow for wide aperture and compensated for maximum sensing width. Neck treble coil South and Bridge bass coil North for both positions

XXP26M-B - Neck

• DC Resistance: ~7.6KΩ
• Resonant Frequency: ~5.7KHz
• Sensing Width: 3.54" [90mm] Max - 2.83" [72mm] Min

XXP26M-T - Bridge

• DC Resistance: ~9.6KΩ
• Resonant Frequency: ~4.1KHz
• Sensing Width: 3.54" [90mm] Max - 2.83" [72mm] Min

P2 Soapbar

• 4.24" [107.7mm] Long, 1.25" [31.8mm] Wide, 0.69-0.79" [17.5-20.1mm] Thick + 0.11" [2.8mm] Cable
• 1 hole on bass end and 1 on treble end for your #4 pan head screws

Please Note: Bartolini does not supply screws with their pickups. If you require pickup screws, we carry them on our pickup screws page.

Click Here for Pickup Screws.