Seymour Duncan STC-3A 3-Band Preamp for Active Pickups

We are not authorized to ship Seymour Duncan products outside of the United States and Canada.

Control Configuration

1. Volume Push/Pull(Slap-Switch)
2. Blend
3. Treble/Bass Stack
4. Mid

High headroom, low-noise, 3-Band active onboard EQ preamp designed for use with active pickups. Comes with prewired 4-knob harness.

Our Tone Circuits will add a tremendous amount of on-board tonal versatility to any dual pickup bass. This design enables players to boost or cut specifically focused frequencies in order to achieve signature tones and to dial in a great sound no matter what the situation. We even added two small trim pots on the circuit board can be tweaked to preset the frequency contour EQ just the way you want.

The STC-3A Tone Circuit provides a 4-knob prewired harness that includes a stacked basstreble control, a midrange control, a master volume, a blend control, and our proprietary Slap Switch. The treble control can produce a wide ranging, extremely usable response that is brilliant, yet smooth without being brittle. Our midrange control can be used to just slightly remove excess midrange honk or to add sonic power that will really make solos jump out. The bass can be reduced to tighten up a boomy instrument, or it can be increased to add warmth and punch.

The Slap Switch is a pushpull located on the volume control. Pulling up on the volume knob will engage the special EQ contour voiced specifically for slap playing. The STC-3A will work in any bass that is equipped with two active pickups and has space for 4 control knobs (volumeslap switch, blend, concentric bass and treble controls) and a single 9v battery in the control cavity. Two 9v batteries can be wired together in series for added headroom.

Package Includes

• All necessary mounting hardware
• High-quality potentiometers on pre-wired harness
• Battery Clip
• Stereo Jack
• Black Anodized, knurled, dome-style knobs

* Noise & thd measurement taken with tone controls set to flat position