This is a demo store. No orders will be fulfilled.
Stellartone ToneStyler Bass Ten
$115.00
SKU
BBG 8079
Stellartone ToneStyler Bass Ten
Stellartone ToneStyler Bass Ten
- Ten EQ circuits, featuring eight hi-cut / mid-cut resonance filters, plus a "virtual tone pot" loading circuit and true bypass
- The "virtual tone pot" loading circuit in switch position #9 precisely-duplicates the original tonality produced by a standard 250kΩ / .047μF bass tone pot when set to maximum brightness.
- Maximum capacitance: .100µF
- Length of our hybrid solid-splined actuator tip has been shortened to .275", to allow zero to low-profile knob heights.
- 1/2" mid-length x 3/8" diameter USA mounting bushing fits surfaces up to 3/8" thick.
- The B-10 is compatible with passive high-impedance basses with two "volume-tone" knobs (P-Bass), or four "volume-tone-volume-tone" knobs (RIC)
- Use one B-10 per volume control
- The BASS TEN's .875" (22.3mm) round footprint is slightly-smaller than a standard 15/16" (24mm) full-sized CTS potentiometer. The low-profile metalized polymer module requires only 0.825" clearance depth (21mm) inside the instrument's control compartment (typically 1.0" to 1.4" depth) Check your clearances before purchase!
* NOT FOR "Volume-Volume-Tone", J-Bass, or Thunderbird (use Bass Duo Six)*
* Does NOT FIT Epiphone 18-coarse-spline metric push-on knobs *
Write Your Own Review


